Products /
DEDIPROG / All-in-one Serial Flash Programmer (SF300)
SF300
Product name : SF300 All-in-one Serial Flash Programmer
Model name : SF300
Discriptons
SF300 comes with all the capability provided by SF300 and SF200. In addition, it
further allows standalone programming without the need of a PC.
Contents and programming procedures are prepared in the SF300 through the software.
LCD display, LED, start button, buzzer, reset counter button are equipped to ensure
good user friendliness during the standalone programming.
Features
USB Interface - load a file, blank check, program and verify the target Serial Flash
Control Application, controller reset and MOSFET isolation status
Window DOS Interface-User can quickly perform some repetitive operations just by
typing the command on our Window DOS interface
Standalone Mode -update the serial flash without computer
High performance(tested and measured with software version 2.0.37.2
and from a single source of serial flash memory supplier)
USB Mode
Density
8Mb
16Mb
32Mb
64Mb
128Mb
Program
7.28s
13.09s
28.01s
52.4s
74.01s
Verify
2.57s
4.64s
8.08s
17.09s
33.78s
Auto(Program+Verify)
8s
14s
37s
70s
108s
Hardware :
SF300 is designed with ISP header, through an appropriate connector,
users can connect the programmer and drive the SPI signals, supply the memory and
control the controller or
application status.Please refer to Table 1 for the SF300
2x7 header pin out.
DediProg also provides the SF300 ISP Cable which is used
to connect the SF300 programmer to the 2X4 2.54mm ISP Pin Header on board, please
refer to Table 2 for the SF300 ISP Cable 2x4 pin out.
.jpg)
.jpg)
.jpg)